Train Movements

Overview

The train movements feed contains messages produced by TRUST. These messages are one of eight types, all in JSON format:

• 0001 - Train Activation
• 0002 - Train Cancellation
• 0003 - Train Movement
• 0004 - Unidentified Train
• 0005 - Train Reinstatement
• 0006 - Change of Origin
• 0007 - Change of Identity
• 0008 - Change of Location

Lifecycle

Before any action can be taken on a train, the schedule must be activated. An [Activation] message will be received, which will link a schedule to a 10-character train identity. This identity is referenced in all other message types, and there is no need to calculate it manually.

A train may be cancelled (either entirely or from a particular calling point onwards) through a [Train Cancellation] message, or start from a location other than the originating location through a [Change of Origin] message. A train may be reinstated after cancellation through a [Train Reinstatement] message.

One point to note - the [Change of Identity] message type is rarely seen. This is used when a train running under one class (e.g. a Class 4 freight with a train identity starting 4---) must run under a different class for some reason - usually because it must run at a lower speed due to the type of load it is carrying.

Data Format

Individual STOMP Packets, can contain between 1 and 32 JSON encoded strings. Each representing a single Train Movement Entry.

Each JSON packet can contain any number of the following columns (depending on available data and message type) Raw Packet Example - All Timestamp columns are in Milliseconds

• msg_type as above
• source_dev_id
• user_id - for when a message is not added Automatically this represents who initiated the message
• original_data_source - known values
  • SDR
  • SMART
  • TOPS
  • TRUST DA
  • TSIA
• msg_queue_timestamp,
• source_system_id, normally TRUST
• train_id
• event_type, is the Train Arriving or Departing, blank for Activation/other messages that are not 0003
  • ARRIVAL
  • DEPARTURE
• gbtt_timestamp
• original_loc_stanox
• planned_timestamp, the timestamp the event is supposed to occur
• timestamp_variation, number of minutes between actual time and reporting time, (always positive, refer to variation_status for early/late)
• original_loc_timestamp,
• current_train_id, used when the the msg_type is 0007, used to link between the old and new train_id
• delay_monitoring_point
• next_report_run_time
• reporting_stanox, the place reporting the update, but STANOX code,
• actual_timestamp, the timestamp the event occurred
• correction_ind
• event_source,
  • AUTOMATIC
  • MANUAL
• train_file_address
• platform, the platform the train is using, (not always populated)
• division_code
• train_terminated, has the train completed this run meaning the end of the train running under its current train_id, it then deactivates
• offroute_ind, is the train running off schedule
• variation_status, qualifier for timestamp_variation
  • EARLY
  • LATE
  • OFF ROUTE
  • ON TIME
• train_service_code, the schedule reference index
• toc_id
• loc_stanox, the Stanox/location of the train
• auto_expected
• direction_ind,
  • UP
  • DOWN
• route
• planned_event_type, the kind of event that was expected
  • ARRIVAL, the train arrived somewhere
  • DEPARTURE, the train left somewhere
  • DESTINATION, the train has reached the end of the line, All Change
• next_report_stanox, STANOX of the next expecte reporting location
• line_ind